***This is a repost of an old post from 2014***

My church is getting into VBS mode as our annual event is quickly approaching.  Our VBS is scheduled for June 9 – June 13, 2014, so we don’t have too much time left to create in anticipation.  We are using Cokesbury’s Workshop of Wonders as our theme this year, and  we are busy coming up with ideas to transform our church into a workshop/art studio to engage the children who join us.

These adorable easels are going to be used as place card holders on our craft table.  The easels are very easy to assemble and very low cost.  I’ve cut out an artist’s palette from cardstock to use as our place card.

Supplies:

• Tacky Glue
• Hot Glue Gun and Glue Sticks – I preferred the clean look of using Tacky Glue for most of the construction of these easel’s, but you could easily use hot glue for all of the construction – especially if you are better with hot glue than I am 🙂
• Skinny Sticks – 3 and 1/2 sticks per easel – I cut the sticks in half using children’s Fiskar scissors.  But watch out!  They fly if you aren’t careful.  I found these at Wal-Mart for $2.47.

Step 1:  Assemble the frame 
Place a dab of Tacky Glue near the top of one full length Skinny Stick.  Attach a second full length Skinny Stick as pictured below so that you form a V with about 3 inches between the open ends of the V.

Step 2:  Add the Cross Bar
Place a dab of Tacky Glue about 2″ up each of the Skinny Sticks as pictured below.  Attach the 1/2 Skinny Stick centered across the two dabs of glue with the skinny edge down.  The wider edge will hold your place card.  Once the Tacky Glue sets a little, carefully wipe/scrape off the excess glue.

Step 3:  Wait
Wait to move the Frame and Cross Bar until after the glue has completely dried.  If you are in a hurry, you can use hot glue for all of these steps.  I prefer the Tacky Glue because I think it looks cleaner when it’s finished, but hot glue is much, much faster so if you are in a hurry, that may be the way you want to go.  

Step 4:  Attach the Support Leg
Place a drop of hot glue on the back of the Frame where the two full length sticks meet.  Attach the support leg by holding the end of the third full length stick firmly against the hot glue you just placed until set.  The support leg should be positioned in the same direction as the two full length legs in the Frame.  You want the support leg to attach at about a 45 degree angle so that the easel is upright, but leaning back slightly so your place card will sit securely.

And that is the finished easel. It worked great for our Workshop of Wonders VBS, but I’m sure it could be a great addition to a lot of cute parties!